New Products

A male to male 50cm servo extension cable Ideal for connecting your home or limit sensor to the RT_EX-Turntable board

This is a 42x42x23mm stepper motor. It has a 5mm D shaft The cable is included with a XH2.54 connector on the end that connects to the ... more info

This is a hall effect sensor for use with RT_EX-Turntable The board is 18mm x 15mm.

This is an all in one board a stepper motor turntable controlled by EX-Turntable. More details for EX-Turntable are available here: EX-Turntable This ... more info

This is an 8 channel I2C isolated multiplexer It combines a TCA9548 I2C multiplexer with an ISO1540 isolator. This protects your command station from ... more info

This board is a 16 channel DCC block detection sensor. The board can be set up in various configurations. The channels can be configured as: 4 4 4 4 ... more info

This is an PCA9555 board for expanding the virtual pins on a DCC-EX command station via an I2C connection. The I2C can either be by Qwiic cables or ... more info

This is an MCP23017 board for expanding the virtual pins on a DCC-EX command station via an I2C connection. The I2C can either be by Qwiic cables or ... more info

This is a PCA9685 board for adding servo control to a DCC-EX command station via an I2C connection. The I2C can either be by Qwiic cables or Dupont ... more info

This is a PCA9685 board for adding servo control to a DCC-EX command station via an I2C connection. The I2C can either be by Qwiic cables or Dupont ... more info