All Products

A male to male 50cm servo extension cable Ideal for connecting your home or limit sensor to the RT_EX-Turntable board

This is a hall effect sensor for use with RT_EX-Turntable The board is 18mm x 15mm.

This is a 42x42x23mm stepper motor. It has a 5mm D shaft The cable is included with a XH2.54 connector on the end that connects to the ... more info

The RT Signal Decoder controls coloured light signals. This version is for common anode LEDS or incandescent globes. It can be configured to control ... more info

The RT Signal Decoder controls coloured light signals. This version is for common cathode LEDS or incandescent globes. It can be configured to ... more info

This board is a 16 channel DCC block detection sensor. The board can be set up in various configurations. The channels can be configured as: 4 4 4 4 ... more info

This is an all in one board a stepper motor turntable controlled by EX-Turntable. More details for EX-Turntable are available here: EX-Turntable This ... more info

This is an 8 channel I2C isolated multiplexer It combines a TCA9548 I2C multiplexer with an ISO1540 isolator. This protects your command station from ... more info

This is an MCP23017 board for expanding the virtual pins on a DCC-EX command station via an I2C connection. The I2C can either be by Qwiic cables or ... more info

This is an MCP23017 board for expanding the virtual pins on a DCC-EX command station via an I2C connection. The I2C can either be by Qwiic cables or ... more info