This is an all in one board a stepper motor turntable controlled by EX-Turntable.
More details for EX-Turntable are available here:
EX-Turntable
This board uses TMC2209 stepper motor controller.
Any stepper motor with a supply voltage of 9-25VDC can be used.
The recommended stepper motor is a NEMA 17
It is fully assembled and tested.
There is no stepper motor, home and limit sensors, led, acc or magnet(s) provided
Operation manual
When ordering please advise the following at checkout:
Motor connector XH2.54 (as supplied on the cable with most NEMA17, second image) or screw terminals.
TRACK IN/OUT screw terminals or pluggable connectors as on the DCC-EX CSB-1 (includes plugs).
If you don't advise which you require then the motor will be XH2.54 and the track will be screw terminals.
This product was added to our catalog on Thursday 12 February, 2026.
