A DCC accessory decoder to control upto 16 servo turnouts or other devices.
This product comes completely assembled and tested.
The output connectors are 3 pin headers for direct conneciton to servos or servo extension leads.
The decoder also has 16 outputs for leds to switch with the servo commands.
The connectors for power and DCC can be either screw terminals or pluggable terminals.
Please advise which you require in the "Special Instructions or Order Comments" at checkout.
This is the bare pcb with all surface mount components in place.
Supplied will be the input connectors, the output connectors for the servos and leds and the two 15pin female headers for the Arduino Nano.
You then need to solder them into place.
The capacitors C2, C3 and C4 are optional and not normally needed.
You will need to supply and program the Arduino Nano.
This product was added to our catalog on Sunday 04 August, 2024.
