Files

Sleds for different products

3D printable sled for any of the accessory decoder boards, the RT_DCD_16 detector board and the RT_EX-Turntable board.
This sled will fit any board that is 100x85mm
It uses 3mm dia x 6mm screws and hex nuts to mount the board.

Firmware

External links to github for firmware to suit accessory decoders and anything that uses an Arduino Nano from this store.

All firmware is complied using platformio.

Whilst the naming convention is as per Arduino IDE there's no guarantee that they will compile in Arduino IDE.

RT_PULSE_8_HP this is also the firmware for the RT_PULSE_8_HP_KATO accessory decoder.

RT_PULSE_8_SERVO

RT_EX-Turntable

RT_Signal_Decoder

RosscoeTrain Firmware Uploader/Configure

RT_Uploader_Configure for Linux

RT_Uploader_Configure for Windows

Click on the applicable version above for your operating system and Save To an applicable location on your computer.

For the linux version you will have to make the downloaded file executable (chmod +x RT_Uploader_Configure)

Open the downloaded file and then follow the instructions depending on your decoder

Mac OS users there is a version under development hopefully by end of May 2026.